PCA Reference Data and Services
Toggle Dark/Light/Auto modeToggle Dark/Light/Auto modeToggle Dark/Light/Auto mode
  2. /
  3. Reference Data Library
  4. /
  5. PLM
  6. /
  7. Detail drawing with parts list

Detail drawing with parts list

A class with identifier http://rds.posccaesar.org/ontology/plm/rdl/PCA_100006161

MetadataThis section provides information about 'PCA_100006161' itself.

Source ontologynorsok-z001
CommentA view or drawing that shows what the inside of equipment looks like after a cross-sectional cut has been made.

The manufacturer's standard detail cross sectional drawing shall be delivered, following content requirements are:

  • Part list with material description.
  • Part numbers can be included or delivered through recommended spare parts list, and is thus not required for all parts.
  • Material definition shall include reference to relevant national/international standards - and material data sheet numbers if additional requirements applies
  • Top Work details in a separate view or sheet shall be included for on/off valves with intended use for gear box or actuator, and if applicable for control valves.
  • Bolt up torque table for pressure containing parts shall be included if not a part of IOM.
NORSOK Z-001 rationaleThis document shall support verification of supplier’s design with regards to functionality and material selection.

This document also supports other documents where a cross-sectional view or part list is necessary for clarity.

NORSOK Z-001 describes structural elementEquipment
NORSOK Z-001 definitionA view or drawing that shows what the inside of equipment looks like after a cross-sectional cut has been made.

The manufacturer's standard detail cross sectional drawing shall be delivered, following content requirements are:

  • Part list with material description.
  • Part numbers can be included or delivered through recommended spare parts list, and is thus not required for all parts.
  • Material definition shall include reference to relevant national/international standards - and material data sheet numbers if additional requirements applies
  • Top Work details in a separate view or sheet shall be included for on/off valves with intended use for gear box or actuator, and if applicable for control valves.
  • Bolt up torque table for pressure containing parts shall be included if not a part of IOM.
skos:broadMatchgeometrical detail information
skos:broaderDrawing

ConstraintsThis section lists constraints that members of 'PCA_100006161' shall satisfy.

ContextThis section provides super- and subtypes as well as members of 'PCA_100006161'.

Document